Artdio IPE 1000 User Manual download pdf (Page 80)

Category Entry Console Mode Console Command

Address

Configuration

tftp server <ip-address |

domain name>

Download

Path/File

Name

Configuration

tftp filename <filename>

TFTP Server

Start

Downloadi

Privileged Two commands (If the TFTP server IP

address and filename have already

been assigned):

copy tftp :///

Or specify the address and file name

at the same time:

copy tftp ://<ip-address>/

If the TFTP server IP address and

filename have been assigned:

If the TFTP servers IP has not been

assigned You may specify the

address and file name

simultaneously:

4.7 Additional Console Commands

Comands Purpose

area

Sets the device’s area code

auto_attn

Sets the auto attendant status

call_route

Sets or deletes an entry in the routing table

cdr

Enables or disables the CDR log

code

Enters the access code configuration mode

country

Sets the device’s country code

cut_through

Sets the access code to skip the greeting message on this

device.

dbflush

Immediately saves the current configuration onto non-volatile

memory. It is recommended that you issue this command

after entering configuration changes. The system will

automatically execute this command if it has detected no

input within a certain time frame.

delete nvram

Resets the configuration to the default value. Also known as

a Factory Reset.

delete nvram

dial_code

Sets the access number for out-bound analysis

exit

Exits the current mode and returns to a higher level

end

Returns to Privileged mode

extension_len

Sets the number of digits for the PBX extension

fax

Sets the T.38 Fax relay configuration

gid_tmr

Timer to erase the group id when system shuts down

greet_mode

Sets the device’s greeting mode

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 90 91

Comments to this Manuals

No comments

Artdio IPE 1000 User Manual Page 80

Comments to this Manuals

Related products and manuals for Hardware Artdio IPE 1000