Artdio IPE 1000 User Manual download pdf (Page 29)

agent.

Reset system, [Y]es or [N]o? Yes

Step 7: Configuring the Prefix for the gateway

The prefix for the gateway should be assigned by the network administrator and configured to the

device. It will be carried in the routing messages to notify the master device of its prefix for other

gateways to route its calls.

Command: PBX GATEWAY (routing)#prefix <prefix for this gateway>

PBX GATEWAY (routing)#prefix 99

PBX GATEWAY (routing)#

Step 8: Configuring the Internal Call Access code for the gateway

Command: PBX GATEWAY(routing-code)#internal_ac <Internal Calls Access code

for this gateway>

PBX GATEWAY(routing)#code

PBX GATEWAY(routing-code)#

PBX GATEWAY(routing-code)#internal_ac *

Step 9: Configuring the Extension Number Length of the PBX

Command: PBX GATEWAY(routing-code)#extension_len <length of extension number

of PBX>

PBX GATEWAY(routing)#code

PBX GATEWAY(routing-code)#

PBX GATEWAY(routing-code)#extension_len 3

(System must be restarted in order for the new configurations to take effect)

Using the Phone Set Interface (please refer to Phone Set Interface Configuration Procedures for more

detailed information)

Step 1: Take the handset off the phone.

Step 2: After hearing the dial tone, dial the PROG Access Code.

Step 3: Enter the Password.

Step 4: Enter code "06" to begin configuring the IP address of the master gateway.

Step 5: Enter the IP address for the master gateway as "0", "*", "0", "*", "0", "*", "0"

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 90 91

No comments

Artdio IPE 1000 User Manual Page 29