Artdio IPE 1000 User Manual download pdf (Page 26)

Using Phone Set Interface

Step 1: Take the handset off the phone

Step 2: Dial the PROG Access Code after hearing the dial tone (default is ##)

Step 3: Enter the Password (default is 0000)

Step 4: Enter code "02".

Step 5: Enter the IP address as "203","*","79","*","238","*","144" and "#" as the ending

prompt. You will then hear the confirmation tone.

Step 6: Enter code "03" to begin the subnet mask configuration.

Step 7: Enter the subnet mask as "255", "*", "255", "*", "255", "*", "128" and "#" as

the ending prompt. You will then hear the confirmation tone.

Step 8: Enter code "04" to begin configuring the IP address for the default gateway.

Step 9: Enter the IP address of the default gateway as "203", "*", "79", "*", "238", "*",

"186" and "#" as the ending prompt. You will then hear the confirmation tone.

System must now be restarted

Step 10: Enter code "98" then press "1" and "#" as the ending prompt. You will then hear the

confirmation tone, and the system will restart automatically.

Place the handset on the phone to end your configuration session.

3.6.2 Obtaining an IP Address From a DHCP Server

Using System Console Interface

Step 1: Enter Privileged Mode

PBX GATEWAY>enable

Password: ******

PBX GATEWAY#

Step 2: Enter Configuration Mode

PBX GATEWAY#configure

Enter configuration commands, one per line. End with CTRL/Z

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 90 91

No comments

Artdio IPE 1000 User Manual Page 26