Artdio IPE 1000 User Manual download pdf (Page 33)

The prefix of the gateway should be assigned by the network administrator and configured to the

device. It will be carried in the routing messages to notify the master device of its prefix for other

gateways to route its calls.

Command: PBX GATEWAY (routing)#prefix <prefix for this gateway>

PBX GATEWAY (routing)#prefix 33

PBX GATEWAY (routing)#

Step 8: Configuring the Internal Call Access code for the gateway (default is "*")

Command: PBX GATEWAY(routing-code)#internal_ac <Internal Calls Access code

for this gateway>

PBX GATEWAY(routing)#code

PBX GATEWAY(routing-code)#

PBX GATEWAY(routing-code)#internal_ac *

Step 9: Configuring the Extension Number Length of the PBX

Command: PBX GATEWAY(routing-code)#extension_len <length of extension number

of PBX>

PBX GATEWAY(routing)#code

PBX GATEWAY(routing-code)#

PBX GATEWAY(routing-code)#extension_len 3

(System must be restarted in order for the new configurations to take effect)

Using Phone Set Interface to Set the IP Address of the Master Gateway on the Slave Gateway

(please refer to the Phone Set Interface Configuration Procedures for more detailed information)

Step 1: Take the handset off the phone.

Step 2: After hearing the dial tone Dial the PROG Access Code.

Step 3: Enter the Password.

Step 4: Enter code "06" to begin configure the IP address of the master gateway.

Step 5: Enter the IP address of the master gateway as "211", "*", "21", "*", "40", "*",

"180" and "#" as the ending prompt. You will then hear the confirmation tone.

Step 8: Enter code "05" to begin the group ID configuration.

Step 9: Enter the group ID as "2009" and "#" as the ending prompt. You will then hear the

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 90 91

No comments

Artdio IPE 1000 User Manual Page 33