Artdio IPE 1000 User Manual download pdf (Page 89)

8. Regional Tone adjustment

For most countries, the tone specifications are not the same. The differences in particular are with the

definitions for Dial Tone, Ring Back Tone, Busy Tone and Reorder Tone. In order to make the PBX gateway

capable of being installed in different countries, the device administrator can change the regional_id

according to which country the device is installed in. If he or she specifies a different regional ID, the ring,

cadence and frequency that is sent out or detected by the PBX voice gateway will be adjusted also .

The command to change the regional_id can be imputed under the Console or Telnet by CLI.

PBX Gateway>enable

PBX Gateway#config

Enter the configuration commands, one per line. End with CTRL/Z

PBX Gateway(config)#regional_id ?

<0-99> Set the value for regional id

PBX Gateway(config)#regional_id 2

PBX Gateway(config)#exit

PBX Gateway#delete nvram ?

all Select the function to delete the NVRAM

keep_ip Select the function to delete the NVRAM

<cr>

PBX Gateway#delete nvram keep_ip

(The command "delete nvram keep_ip" is functioning as the factory reset but will keep the IP

address configuration for this device and the regional_id, after doing this; you should again

re-configure the device).

After the system boot-up again, use “show run” to check the new configured regional ID.

The default value is set to "00" for the regional_id, but it may be equivalent to some of the regional_ids

listed below. This depends on which regional_id will be entered as the default value.

Regional_id Country

06 Canada

07 China

12 France

15 Hong Kong

22 Italy

23 Japan

Regional_id Country

36 Singapore

Slovenia

Spain

Taiwan

Great Britain

United States

Table 8-1 the table of regional IDs and their corresponding countries

1 2 ... 84 85 86 87 88 89 90 91

No comments

Artdio IPE 1000 User Manual Page 89