Artdio IPE 1000 User Manual download pdf (Page 27)

PBX GATEWAY (config)#

Step 3: Enable DHCP Mode

PBX GATEWAY (config)#ip state dhcp

PBX GATEWAY (config)#

Step 4: Back to Privileged Mode

PBX GATEWAY (config)#exit

PBX GATEWAY#

Step 5: Restart the system to enable DHCP mode. After the restart command is issued, the system

will prompt for a confirmation.

PBX GATEWAY#restart

This command restarts the system. The system will now restart operation code

agent.

Reset system, [Y]es or [N]o? Yes

Using Phone Set Interface (please refer to the Phone Set Interface Configuration Procedures for

more detailed information)

Step 1: Take the handset off the phone. Step 2: After hearing the dial tone dial the PROG Access

Code.

Step 3: Enter the Password.

Step 4: Enter code "01" to begin configuring the DHCP state.

Step 5: Enter "1" to enable DHCP client and "#" as the ending prompt. You will then hear the

confirmation tone. (Or enter "0" to disable the DHCP client and "#" as the ending prompt).

System must now be restarted

Step 6: Enter code "98" then press "1" and "#" as the ending prompt. You will then hear

the confirmation tone, the system will then restart automatically.

Place the handset on the phone to end your configuration session.

The (default) password for the Phone Set Interface is "0000".

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 90 91

No comments

Artdio IPE 1000 User Manual Page 27